The small swinging particle machine produces particles with low powder content, convenient operation, simple control, long service life, and complies with GMP specifications. The poor flowability of powder can easily cause cracking and large differences in tablet weight. Therefore, before pressing, particles are made. This type of machine is generally used for granulation of Chinese and Western medicine, because the particles produced by this type of machine have good flowability and the weight of the pressed tablets is uniform.

　　This product can be used to make wet powder into particles, as well as to break and disperse some fragile, loose, and brittle materials in strip and irregular shapes, as a pre grinding process. One machine has three functions: granulation, crushing, and fabric distribution, which can achieve the goal of multiple uses.

　　The small swing granulator should be maintained and serviced in the following way in daily life:

　　(1) Machine lubrication: Lubrication cycle: ① Generally, the machine parts should be lubricated every three days of operation; ② Add 1 # calcium based grease to rolling bearings every 3 months.

　　(2) Machine maintenance

　　1) Maintenance cycle: ① Electric motor: inspected once a month; ② After each shift, conduct an overall inspection of the machine.

　　2) Maintenance content: ① Regularly check the insulation resistance and reliability of zero connection of various components and control circuits in the electrical system to ensure electrical safety; ② Regularly inspect the components (once a month), check whether the moving parts such as worm gear, worm gear, bearings, etc. rotate flexibly and wear out. If defects are found, they should be repaired in a timely manner and cannot be used again; ③ The transmission part of the equipment should be refueled once before driving, and can be added midway according to the operation of each part; ④ The worm gear box must store engine oil for a long time, with the oil level at a height where the worm gear is completely immersed in the oil. When using the machine continuously, the oil must be changed every three months; ⑤ Before operating the equipment, idle it and confirm that it is running normally with good lubrication before it can be operated normally; ⑥ After a small swing granulator is used or stopped, the rotating drum should be taken out for cleaning and brushing the remaining powder in the hopper, and then installed properly to prepare for the next use; ⑦ If the machine is not used for a long time, it must be cleaned thoroughly.